Raymarine ST60 Installation Manual download pdf (Page 34)

ST60 Tridata Instrument Owner’s Handbook

Bracket mounting

A Control Unit Mounting Bracket (Part No. E25009) enables you to

mount your ST60 instrument in locations where other forms of

mounting are impractical. Although this provides a useful alternative

method for securing your instrument, it is only suitable for use in

positions where the instrument will not be exposed to water.

To bracket mount your ST60 instrument, do so in accordance with the

Control Unit Mounting Bracket Instruction Sheet.

Fitting transducer

The ST60 Tridata instrument is supplied, with appropriate through-

hull Speed and Depth transducers.

Each transducer is supplied with detailed instructions for installation

and maintenance. Before attempting to install a transducer, read these

instructions and the Site requirements for transducers described in this

Chapter.

Once you are satisfied you can meet all the installation requirements,

install the transducer in accordance with the accompanying installation

instructions.

Running transducer cable

Each transducer type has a 14 m (45 ft) cable fitted with spade

terminals for connection to the ST60 Tridata instrument. The manner

in which you run the cable will depend on the locations of the

transducer and instrument. The following guidelines are provided:

• If the cable has to be fed through the deck, always use a proprietary

deck gland.

• Where cables are fed through holes, always use grommets to

prevent chafing.

• Secure long cable runs so they do not present a hazard.

• Do not route the cable through bilges.

• Wherever possible, route the cable away from fluorescent lights,

engines, radio transmitting equipment, as these may cause

interference.

040_3c03.p65 06/04/01, 10:2122

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

No comments

Raymarine ST60 Installation Manual Page 34