Raymarine Satellite TV Systems User's Guide Page 48

  • Download
  • Add to my manuals
  • Print
  • Page
    / 66
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 47
44 Raymarine 37STV Satellite TV System
Note: *for an explanation of the possible causes and their rem-
edies refer to the following paragraphs.
1. Blown fuse, low power or wiring
Check that the in-line quick blow fuse (if fitted) has not
blown, or the circuit breaker has not tripped. Replace fuse
with one of the same type and rating.
If you have extended the power cable from the antenna unit,
check that there is no power loss.
Check the system wiring and connections.
2. Satellite Signal Blocked
Satellite signals can be blocked or degraded by buildings, other
boats or equipment on your boat. Check that the antenna has a
clear view of the sky.
3. Outside satellite coverage zone
Your system will provide excellent reception within the antenna
coverage area for your satellite television service. However,
signal quality may degrade as you approach the edges of this
zone. Refer to “Satellite coverage areas” on page 47 to check
the viable coverage area for your antenna.
4. Radar interference
The energy levels radiated by radar units can overload the
antenna front end circuits. Make sure that your antenna is
installed as described in “Planning the installation” on page 8 of
this handbook with regards to your radar unit.
5. Incorrect or loose RF connectors
As part of the regular maintenance recommended by
Raymarine, all connections should be checked to ensure that
they have not become loose. A loose RF connector can reduce
signal quality or cause the antenna not to work.
6. Multi-switch interference
If you have multiple IRD’s connected to your system, make sure
that you are using an ACTIVE not PASSIVE multi-switch.
7. IRD troubleshooting
Your IRD may be the cause of less than ideal operation.
Check the IRD’s configuration to ensure that it is pro-
grammed for the area in which you are operating.
Unplug the IRD from the power supply for 15 seconds.
Reconnect and allow the system to initialize.
8. LNB fault
If you have an LNB fault it may require replacing. Contact your
local dealer, national distributor or Raymarine Product Support
for further assistance.
‘Snowy’ television picture X
Symptom
Possible cause*
1 2 3 4 5 6 7 8
81304_1.book Page 44 Tuesday, July 31, 2007 2:44 PM
Page view 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 65 66

Comments to this Manuals

No comments