Raymarine SportPilot Specifications download pdf (Page 52)

48 SportPilot and SportPilot Plus - Owner’s Handbook

4 Installing the SportPilot

4. Secure the torque bracket and cable sealing mat to the bulkhead

using the four self tapping screws.

5. Assemble the SportPilot to the steering shaft.

6. Retain the SportPilot using the split washer and retaining nut.

CAUTION:

Do NOT attempt to support the SportPilot during tightening.

Make sure the torque restraint bolt is removed so the SportPilot

is free to rotate as you tighten the retaining nut. This will prevent

damage to the SportPilot clutch.

7. Tighten the retaining nut to 25 lbft (34 Nm) maximum against the

steering end stop.

8. Assemble the steering boss to the SportPilot.

9. Secure the steering boss using the 4 screws and washers.

10. 1 inch (25 mm) steering shafts only:

• assemble the adaptor collar to the steering boss

• once assembled, fit the Raymarine woodruff key

11. Assemble the steering wheel to the SportPilot.

12. Secure the wheel using the nut and the washer. Make sure that

the woodruff key is fitted before tightening the wheel.

D1369-2

Torque

bracket

Torque bracket

screw

Torque

restraint

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

No comments

Raymarine SportPilot Specifications Page 52