Raymarine ST60 Specifications download pdf (Page 45)

Calibration 33

Adjust to SOG

The Adjust to SOG screen isdisplayedonlyifSOGdata is available from

SeaTalk. The current SOG is displayed in the bottom section of the

display(SG12.8 in the illustration),and the currentspeedregisteredbythe

instrument, as large figures in the middle section of the display (12.3 in

the illustration).

It is recommended that, if you are running in slack tide conditions, you

press the

reset key for 3 seconds, to accept the SOG as the current speed.

If you do not wish to accept SOG as the current speed, press the

trip and

reset keys together to select the Cal factor adjust display.

Cal factor adjust

The Cal factor adjust screen enables you to manually adjust the

calibration factor. It shows the current calibration factor in the bottom

section of the display(CF 1.00 in the illustration), and the current speed as

large figures (12.3 in the illustration).

Usethe

trip or reset keyto adjust the calibration factor so that the current

speed is the speed through the water.

If SOG data is available from SeaTalk, you can turn to the Adjust to SOG

screen by pressing the

trip and reset keys.

Note:If neither of the above methods gives satisfactory results, carry out

the Speed calibration procedure (part of Intermediate calibration).

Set temperature units

Select either °C or °F, as required.

Temperature calibration

Set the display to show the current water temperature.

Timer alarm buzzer

Switches the count-up and race-start timer audible alarm on the ST60

Tridata instrument being calibrated, on and off.

Leaving User calibration

Holddownthedepth and speed keys for 2 seconds,tosave your settings,

exit User calibration and resume normal operation.

81040_1.book Page 33 Thursday, November 7, 2002 10:21 AM

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

No comments

Raymarine ST60 Specifications Page 45