Raymarine Radar Scanner User Manual download pdf (Page 41)

Chapter 2: Installing the Scanner 33

Fitting the open array to the pedestal

CAUTION:

The pedestal unit has a cap fitted over the open array mounting

shaft to protect the protuding co-axial pin. This cap must be left

in place until the open array is fitted to the pedestal.

1. Remove the cap from the open array shaft. Retain the cap, it will

be required if the open array is removed from the pedestal.

2. Grease the four securing studs.

CAUTION:

If the pin is damaged during the following operation you should

contact your service dealer.

3. Lift the open array into position. Carefully lower the array - to pre-

vent damage to the mounting pin, ensure the array remains paral-

lel to the pedestal so that the studs slot into the holes on the

pedestal mounting bracket.

Note: The open array mounting bracket is designed so that the array

can only be fitted to the pedestal in the correct orientation.

4. Use the four nuts and associated washers supplied to secure the

array to the pedestal as shown in the diagram below.

M8 plain washer

M8 spring washer

M8 nut

Array

Pedestal

D4580-2

154_4.book Page 33 Wednesday, October 25, 2000 3:02 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 65 66

No comments

Raymarine Radar Scanner User Manual Page 41