Raymarine RS232 Installation Manual download pdf (Page 9)

Operation and Installation 7

damage the equipment, but may cause the loss of some information and may

change the operating mode.

• Raymarine specified cables are used at all times. Cutting and rejoining these

cables can compromise EMC performance and so must be avoided unless

doing so is detailed in the installation manual.

• If a suppression ferrite is attached to a cable, this ferrite should not be

removed. If the ferrite needs to be removed during installation it must be

reassembled in the same position.

The following illustration shows typical cable suppression ferrites fitted to

Raymarine equipment. Always use the ferrites supplied by Raymarine.

D3548-2

Connections to Other Equipment

If your Raymarine equipment is to be connected to other equipment using a

cable not supplied by Raymarine, a suppression ferrite MUST always be fitted

to the cable close to the Raymarine unit.

EMC Conformance

Always check the installation before going to sea to make sure that it is not

affected by radio transmissions, engine starting etc.

166_3chs.p65 24/01/02, 11:217

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Raymarine RS232 Installation Manual Page 9