Raymarine ST50 plus User Manual download pdf (Page 24)

ST50 Plus Tridata and Repeater Operation and Installation Handbook

Chapter 7: Connection to other Marine Equipment

The ST50 Plus Tridata can only be connected to other SeaTalk products.

However, the ST50 PIusTridata Repeater can communicatewith other

onboard marine electronic equipment, using the NMEA0183 protocol.

A lm

(3ftl

NM!4

interface cable is supplied with every repeater unit. The red

wire should be connected to the signal input. Up to two NMEA0183

receivers may be connected to each repeater with NMEAoutput.

RED (Signal) 2

i-‘-

BLUE (Ground)

The ST50 Plus Tridata Repeater has an NMEA0183 data output connector.

The following information will be transmitted every 1 to 2 seconds if it is

available on the SeaTalk bus.

Sentence Content Instrument Required

VWR Apparent Wind Speed (Knots)

ST50 Plus Wind

& direction

DBT

Depth of Water below the

Transducer (Feet)

ST50 Plus Depth or Tridata

HDM

Magrxtic Heading

HSC

Locked Magnetic Heading

ST50 Plus Steering Compass

SeaTalk Autopilot (Lock

Model

VHW

Water Speed (KNots) ST50 Plus Speed or Tridata

MTW

Water Temperature

1Deg.C)

ST50 Plus Speed or Tridata

VTG

Course & Speed over Ground Navigation Receiver

GLL

BWC

Latitude & Longitude

Bearing & Distance to

Wavpoint

Navigation Receiver

1 ... 23 24 25

Comments to this Manuals

No comments

Raymarine ST50 plus User Manual Page 24

Comments to this Manuals

Related products and manuals for Security access control systems Raymarine ST50 plus