Raymarine 600XX Specifications download pdf (Page 21)

Chapter 2: Installation 11

2.6 System Connections

The rear of the fishfinder provides the following connection sockets:

• Power/NMEA

• Transducer

Figure 2-3: DS600X Connector Panel

DC Power and NMEA Connection

The DS600X is intended for use on boat’s DC power systems rated from 10-

18 Volts DC (13.8V nominal).

A 5 ft (1.5 m) cable is supplied for connecting the boat’s DC power and

NMEA interface to the unit. This Power/NMEA cable can be extended by up

to 60 ft (20 m) using a wire gauge of AWG 12 or greater.

The cable’s molded end attaches to the seven-pin Power/NMEA connector

on the unit’s connector panel.

The cable connector (viewed from the outside) is shown in the following

drawing.

Figure 2-4: Power Cable Connector

The exposed wires on the open end of the cable should be connected as

follows:

D6460-2

Power/NMEA Transducer

D6462-2

pin1

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

No comments

Raymarine 600XX Specifications Page 21