Raymarine ST70 Installation Guide download pdf (Page 18)

SeaTalk systems:

• Label both ends of the SeaTalk

-to-SeaTalk adaptor cable, and attach it to an

existing instrument or connect it to a connector block on the system.

• Route the cable to the location in which you plan to mount the ST70 controller.

Note: Check that the cable reaches the required location. If you wish to place the ST70 control-

ler further than 400mm from the connection point you will need to purchase an appropriate

SeaTalk

or SeaTalk

-to-SeaTalk cable.

2. Cut mounting holes

• Use the appropriate flush- or surface-mount template to cut the mounting slot for

the autopilot controller and to drill holes for the fixing screws. See the back of this

book for templates.

• Clean and de-burr the mounting surface

ST70 controller

ST60+ instrument

D10421-1

SeaTalk cable

SeaTalk 3 way block

SeaTalk cable

ST70 controller

ST60+ instrument

SeaTalk

to SeaTalk cable

SeaTalk

SeaTalk cable

87071-1.book Page 10 Monday, April 21, 2008 3:34 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

No comments

Raymarine ST70 Installation Guide Page 18