Raymarine ST60 Specifications download pdf (Page 17)

Chapter 1: Operation 5

3. Press any other button to leave the illumination-adjust mode.

Note:

The display will time out to normal operation 7 seconds after the last button press.

Contrast

To adjust the display contrast:

1. Enter the illumination-adjust mode as described above.

2. Hold down the

depth button for a further two seconds approximately, to

enter the contrast-adjust mode.

3. There are four preset contrast settings. Momentarily press the

depth button

to cycle through these settings until you achieve optimum display quality.

4. Press any other button to leave the contrast-adjust mode.

Note:

The display will time out to normal operation 7 seconds after the last button press.

1.4 Pop-up Pilot

A Pop-up Pilot facility enables instruments connected to SeaTalk to constantly

monitor any changes to the autopilot mode and to the course settings. If one of

these parameters changes, the new value is immediately displayed on the ST60+

instrument for 5 seconds, after which time the display reverts to the previous

display.

This facility can be enabled or disabled during User calibration (see

Chapter 4,

Calibration

1.5 Remote control

When it is connected to SeaTalk, the ST60+ Depth instrument can be controlled

remotely with a SeaTalk Remote Keypad Unit. Remote control of an instrument is

indicated by a REMOTE legend on the display, to indicate that the keypad has

control.

Details on how to use the remote control facility can be found in the

SeaTalk

Remote Keypad Owner’s Handbook

81262_2.book Page 5 Monday, December 5, 2005 9:02 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

No comments

Raymarine ST60 Specifications Page 17