Raymarine VolvoPenta IPS Autopilot System DPU Installation Manual download pdf (Page 19)

Chapter 1: System Connections 9

Securing the Cables

1. Strip at least 5 mm (¼ in) of insulation from the end of each cable

2. Use a small screwdriver to push the small plastic lever on top of the terminal

and release the cable clamp

3. Insert the stripped cable and release the lever to grip the cable

1.7 How to connect SeaTalk equipment

Note:

For Volvo Penta IPS autopilot systems, please refer to the Connections guide sup-

plied with the DPU.

You can use SeaTalk to connect your SmartPilot to:

• additional SeaTalk controllers: you can use any controller to operate the

SmartPilot and view autopilot information

• SeaTalk equipment (such as instruments, chartplotters, radar and GPS):

• the SmartPilot can use information from this equipment to enhance

course keeping and provide additional features.

• you can also display information from the SeaTalk equipment on the

SmartPilot controller.

The following illustrations show some typical ways to connect simple SeaTalk

systems.

Single control unit, single power supply

The simplest type of system has the SmartPilot computer providing power to a

single SeaTalk bus that includes a single controller and several instruments.

D6300-1

Single control unit, single power supply

SmartPilot

controller

SeaTalk instruments

SeaTalk bus

Course computer

power supply

(via breaker/fuse)

SmartPilot

computer

SeaTalk

81273_1.book Page 9 Monday, December 5, 2005 10:32 AM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

No comments

Raymarine VolvoPenta IPS Autopilot System DPU Installation Manual Page 19