Raymarine VolvoPenta IPS Autopilot System DPU Installation Manual download pdf (Page 53)

Chapter 3: Adjusting SmartPilot Settings 43

Data pages

SmartPilot controllers have 15 user-configurable pages. The following screens

allow you to modify the settings for the data pages. These define which SeaTalk/

NMEA data pages will be available during normal operation (see

SmartPilot

Operating Guide

). Each data page setup screen initially shows the title DATA

PAGE and the page number. After 1 second, the text changes to the title of the

data set for that page.

The default settings are:

Note:

It is good practice to keep the

BTW

and

DTW

pages for display. If your SmartPi-

lot receives a man overboard

(MOB)

message, these data pages will show the bearing and

distance to the

MOB

location.

To change the data displayed on a data page:

1. Press disp to move to the appropriate data page setup screen.

2. Use the -1 and +1 keys or the rotary control to scroll forwards or back-

wards through the available data pages (see following table).

3. Then press disp to move to the next data page you want to change, or press

and hold standby for 2 seconds to save changes.

Data Page Default Setting

1XTE (Cross Track Error)

2BTW (Bearing to Waypoint) - see Note below

3DTW (Distance to Waypoint) - see Note below

4RESPONSE

Remaining pages NOT USED (These pages are not displayed when you scroll

through the data pages during normal operation)

Available Data Pages Displayed as

Speed Knots

SPEED KTS

Log

LOG XXXX.X

Trip

TRIP XXX.X

Average Speed, Knots

AV. SPD KTS

Wind Direction

e.g.

WIND PORT

Wind Speed

WIND KTS

81273_1.book Page 43 Monday, December 5, 2005 10:32 AM

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 79 80

Comments to this Manuals

No comments

Raymarine VolvoPenta IPS Autopilot System DPU Installation Manual Page 53

Comments to this Manuals