Chapter 2: Setting Up Graphic Displays 7-2-31
ST290 Instrument System Owner’s Handbook
2.7 Pilot setup
WARNING:
Itis imperative that autopilotsetup is completedbeforetheautopilot
is used, to ensure safe navigation.
If you are intendingto use anST290 Pilot Keypad tocontrol an autopilot,
you must carry out the autopilot setup procedures. Three autopilot setup
chapters are provided as part of User Setup:
• BASIC
• SEATRIAL
• ADVANCED
For details on the autopilot setup requirement and procedures, refer to
Section 8, Autopilots.
2.8 Data Units
The DATA UNITS page enables you to set the units in which data is
displayed. You can set:
• SPEED units to either KNOTS, KM/H or MPH.
• DISTANCE units to either NM, KM or SM.
• DEPTH units to either FEET, FATHOMS or METERS.
• WIND SPEED units to either KTS or M/S.
• TEMPERATURE units to either °
c or ° F.
• FLOW RATE units to either G/H or L/H.
The DATA UNITS are global settings (the units you set are applied to the
whole ST290 system), so only need to be made at one instrument.
Figure 2-28: Setting data units
D5947-1
81183_2 S7.book Page 31 Wednesday, May 7, 2003 1:52 PM
Comments to this Manuals