Raymarine ST70 Installation Guide download pdf (Page 12)

6 ST70 Instrument User Reference Manual

Power protocol

Power to each individual ST70 instrument can be switched on and off using the power

button (as described in the ST70 Operating Guide). However, where instruments

are part of a system, it may be more convenient to switch power for the entire system

from a central circuit breaker.

In this case, when system power is switched ON again:

• ST70 instruments that were switched on when power was last switched off will

return to the switched ON state.

• ST70 instruments that were OFF when system power was last switched OFF will

remain OFF and will need to be switched ON individually using their power but-

tons.

1.3 Commissioning requirement

After installation, each ST70 instrument that is NOT part of a SeaTalk

system in

which at least one other ST70 instrument is already set up and working must be

commissioned in accordance with Chapter 2: Commissioning Procedures, before it is

used for operational purposes.

Note: if an instrument is part of a system in which at least one other ST70 instrument is already

set up and working, you do not need to commission it.

Refer to the ST70 Instrument Operating Guide for instructions on how to use the ST70

instrument on a day-to-day basis.

WARNING: Product installation & operation

Each ST70 instrument must be prepared for use in accordance with the

Commissioning Procedures, before it is used for operational purposes,

unless it is part of a SeaTalk

system in which at least one other ST70

instrument is already set up and working, it. Failure to comply with this

could result in death, personal injury, damage to your boat and/or poor

product performance.

81284_1.book Page 6 Friday, May 4, 2007 7:29 AM

www.Busse-Yachtshop.de [email protected]

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

No comments

Raymarine ST70 Installation Guide Page 12