Raymarine ST70 Installation Guide Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
22 ST70 Instrument User Reference Manual
6. Use
<
or
>
to select the next calibration speed.
7. Repeat Set to SOG steps 2 to 6, until calibration factor values have been set for all
calibration speeds.
8. Press
ENTER
to save the values and return to the
Speed
transducer setup menu.
9. Press
CANCEL
to return to the Transducers found menu.
Manual calibration
To manually set the correct speed:.
1. Carry out the Start calibration
procedure (above)
2. In conditions of zero tide and zero
current, run your vessel at a steady
speed approximately that of the
selected calibration speed, over a
measured distance.When you do this,
make a note of:
The current speed value.
The time it takes to cover the
measured distance.
3. Calculate the actual speed over the measured distance (distance/time).
4. If the calculated speed is:
The same as the current speed value noted during the calibration run, then the
calibration is correct at this speed, so proceed from Manual calibration step 6.
Not the same as the indicated speed:
i. Calculate a new, corrected calibration factor, as follows
ii. Press to highlight the calibration factor value field.
iii. Use
<
or
>
to set the displayed calibration factor to the new calculated
value.
5. Repeat Manual calibration steps 2 to 4, until the current speed value displayed
during the calibration run is the same as the calculated speed.
6. Press to highlight the calibration speed field.
7. Use
<
or
>
to select the next calibration speed.
8. Repeat Manual calibration steps 2 to 7, until the calibration factor values are
correct at all calibration speeds.
9. Press
ENTER
to save the values and return to the
Speed
transducer setup menu.
10. Press
CANCEL
to return to the Transducers found menu.
D10323-1
1.8
2 KTS
Calibration
i
Press ENTER to accept
Calibration factor
Calibration speed
Current
speed
value
See Docs for Manual Calibration.
Speed 1.2KTS
new calibration factor =
indicated speed
actual speed x old calibration facto
r
81284_1.book Page 22 Friday, May 4, 2007 7:29 AM
www.Busse-Yachtshop.de [email protected]
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Comments to this Manuals

No comments