Raymarine St290 Specifications download pdf (Page 175)

7-2-18 Section 7: System Setup

ST290 Instrument System Owner’s Handbook

Use the following procedure for each instrument you want to be able to

remotely control:

1. With the remote setup page displayed (Figure 2-20 ), use the or

button to highlight the REMOTE GROUP field.Thisenables you toallo-

cate the instrument as part of a remotely controlled group

2. Hold down the button for 1 second to enter edit mode. The field

value flashes.

3. Use the or button to select the remote control group for this

instrument.Thiscanbe in anyone of eightgroups,identifiedby letter,

from A to H.

4. Hold down the button for 1 second to leave the edit mode.

5. Use the or button to highlight the SEQUENCE NO. field.

6. Hold down the button for 1 second to enter edit mode. The field

value then flashes.

7. Use the or button to set a number, to define the sequence in

which the instrument is selected within its remote group.

8. Hold down the button for 1 second to leave the edit mode.

9. Use the or button to highlight the LINK KEYPAD(S) field. This

enables you to define which Remote Keypad(s) you want to use to

control the instrument. If a Remote Keypad is not already allocated,

is displayed.

10. At each Remote Keypad you want to use to control this instrument,

press any button on, to link the instrument and keypad. Once a link is

created, a is displayed against the LINK KEYPAD(S) field.

2.6 Transducer calibration procedures

Requirement

Transducer calibration ensures that the data provided by the transducers

gives correct readings at the instruments.

Transducer calibration is applied globally to the ST290 system, and so

only needs to be done once from one Graphic Display.

An overview of the transducer calibration functions is given in Figure

2-21 .

81183_2 S7.book Page 18 Wednesday, May 7, 2003 1:52 PM

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 298 299

No comments

Raymarine St290 Specifications Page 175