Raymarine GyroPlus Yaw Sensor Setup Guide Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 38
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
Chapter 1: Basic Operation 9
3. The display automatically returns to the previous mode if you do not press a
button for 10 seconds.
If you press another mode button within 10 seconds you will select the associated
mode. For example:
auto
selects Auto mode,
standby
selects Standby mode.
Notes: (1) You can also adjust the lighting level from other SeaTalk instruments or control
units.
(2) When you switch off, any changes you have made to the lighting level will be lost.
Contrast
To set the display contrast level:
1. With the autopilot in Standby mode, hold down
disp
for one second to access the
LAMP
screen.
2. Hold down
disp
for one second again, to display the
CONTRAST
screen.
3. Use
+1
and
-1
to set the required contrast level (from
1
to
15
).
4. The display automatically returns to the previous mode if you do not press a
button for 10 seconds.
If you press another mode button within 10 seconds you will select the associated
mode. For example:
auto
selects Auto mode,
standby
selects Standby mode.
1.6 Data pages
A series of data pages on the Pilot Controller enables you to quickly monitor various
information from your SPX-5R Drive system. To access these data pages:
1. Press
disp
to access the first data page.
2. Press
disp
again to cycle the next data page, then continue this process to reach
the page you want.
3. When all pages have been displayed and you press
disp
again, the display
returns to the current SPX-5R Drive system mode screen (for example,
AUTO
).
When you first use your SPX-5R Drive system, four data pages are available, as in the
following illustration, but you can configure up to fifteen data pages during Display
calibration, as detailed in the SPX-5R Drive Installation & Commissioning Guide.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Comments to this Manuals

No comments