Raymarine GyroPlus Yaw Sensor Setup Guide download pdf (Page 8)

2 SmartPilot X-5R Drive Operating Guide

For further information on other connections to your system refer to the SmartPilot

X-5R Drive Installation & Setup Guide.

1.2 Using the control unit

Switching on and off

When power is applied to the Pilot Controller, you can use the

disp

button to

switch it off and on as follows:

• To switch the Pilot controller off, ensure it is in the Standby mode, then hold down

disp

for approximately 5 seconds. After this time, a switch off count down of

4 seconds occurs. Keep

disp

pressed during this period, to switch off the

instrument.

• To switch the instrument back on, hold down

disp

for approximately 1 second.

If power is not applied, the Pilot Controller buttons have no effect.

Notes: (1) Each time power to the Pilot Controller is switched on, the controller is initially in the

on condition. You do not need to use

disp

to switch the controller on.

(2) When the controller is on, the operation of

disp

initiates other operating

functions, as described below.

Start-up mode

The SPX-5R Drive system always powers up in Standby mode with the Pilot

Controller display showing the boat’s current compass heading.

Keypad functions

The SPX-5R Drive system is controlled by button presses at the Pilot Controller.

Button operation is confirmed with a short beep. Single-button and dual-button

operations are used.

auto

Press for Auto mode

Course change keys

Port 1˚ Starboard 1˚

Port 10˚ Starboard 10˚

-1 plus -10

Press together for 90˚

AutoTurn to port

D10690-1

disp

Press to display data pages

Press for 1 second for lamp

adjust

Press for 3 seconds for

contrast adjust

Press for 9 seconds

(in Standby mode) for

power down

When powered down, press

for 1 second to power up

standby

Press for Standby mode

Press for 2 seconds to enter

Calibration mode

-1 plus +1

Press for

Response level

track

Press for Track mode from

Auto (if a navigator is

connected)

Press to accept waypoint

advance

Press for 1 second to skip

waypoint

+1 plus +10

Press together for 90˚

AutoTurn to starboard

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Comments to this Manuals

No comments

Raymarine GyroPlus Yaw Sensor Setup Guide Page 8

Comments to this Manuals

Related products and manuals for Navigators Raymarine GyroPlus Yaw Sensor