Raymarine ST1000 Plus Specifications download pdf (Page 52)

50 ST1000 Plus & ST2000 Plus Tiller Pilots

1. Press -1 and +1 together for 5 seconds.

2. The display shows the new operating sense (port or starboard) for 5 seconds,

and then the autopilot reverts to normal operation.

Checking the navigation interface

If you have connected the tiller pilot to a navigator, check the interface as follows:

1. Set up a track on the navigator to give a Cross Track Error between 0 nm and

0.3 nm.

2. Enter Auto mode by pressing

auto.

3. Enter Track mode by pressing

-10 and +10 together.

4. An alarm will sound and the display will alternate between the bearing to

waypoint and the direction the boat will turn to acquire it.

5. Make sure that it is safe to turn onto the new course, then press -10 and +10

again.

6. If the navigator is connected correctly, the display will begin to cycle through

the available navigation data:

Navigation error screens

If the display shows either of the following error displays, the cause is either:

• a wiring error, or

• the navigator is not configured to transmit the required data format

D208-2

D3267-2

Locked heading

Distance to waypoint

(if available)

Bearing to waypoint

(if available)

Cross track error

81130_6.book Page 50 Wednesday, March 8, 2006 3:12 PM

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 75 76

No comments

Raymarine ST1000 Plus Specifications Page 52