Raymarine FishFinder L265 User Manual download pdf (Page 35)

Auto zoom on (Z)

The “zoom” can be used to magnify the image from a small

section of the water below the boat. (This is used with the

Zoom display, which we will describe in a moment.) When

the auto zoom feature is on, the FishFinder automatically

moves the zoom window up or down to track the bottom.

Fish symbol on

When the FishFinder sees a fish, it can show this by

displaying a fish symbol. When the fish symbol feature is

turned off, the FishFinder indicates a fish as an arch-

shaped line on the display. For more information, see the

section on “Fish Indications.”

Boat symbol This symbol is always turned on. It indicates that the new

information appears at the right edge of the display, and the

older information moves toward the left.

Center of display

Water surface This symbol (“0”) shows the depth indicated by the top of

the display. Usually, this is the level of the surface of the

water. (If the Zoom feature is turned on, this will show the

depth of the top of the zoom area.) The depth is shown

using the same units as the rest of the display. This could

be feet (FT), fathoms (FA), or meters (M), depending on the

setting you make in the System Setup display.

Depth markers

These markers show depths between the surface and the

full depth range. In this example, the unit is set for a depth

range of 100 feet. This means that each of the depth

markers shows an interval of 20 feet.

Fish symbol This indicates that the FishFinder sees a fish. Generally,

the larger the fish symbol appears, the larger the fish. (The

size of the fish symbol actually depends on a number of

factors. See the section on “Fish Indications.”)

Operating Instructions

1 ... 34 35 36 ... 79

No comments

Raymarine FishFinder L265 User Manual Page 35