Raymarine FishFinder L265 User Manual download pdf (Page 36)

If the fish is detected using the narrow 200 kHz beam, the

display will show a filled-in symbol. If the fish is detected by

the

wide 50 kHz beam, the display will use a hollow symbol.

(For more on this, see “Choosing the Frequency.”)

Fish depth This indicates the depth of the fish shown by the fish

symbol. This number will be shown using the same depth

units (feet, fathoms, or meters) you have selected on the

System Setup display. The fish depth indicator is turned off

when the fish symbol function is off.

Bottom of display

Bottom indication

This shows the bottom of the lake or sea. You can com-

pare this to the range depth shown in the lower right-hand

corner. (In this example, the checkered pattern shows the

unit is getting a strong echo return from the bottom. See

the information on the White Line feature in the Setup

Instructions.)

Range The “range” is the maximum depth the unit is set to

measure. In this example, this is 100 feet. You can set the

range manually, or the FishFinder can do it automatically.

Bottom depth This is the depth of the bottom shown on the display. You

can select FT (feet), FA (fathoms), or M (meters) using the

System Setup display. If the FishFinder can’t tell how deep

the water is, the last known depth flashes on the display.

This will continue until the unit can see the bottom again.

Buzzer symbol

This symbol shows whether any of the alarms will use the

buzzer. There are three kinds of alarms: shallow, deep, and

fish. If one of these alarms is set, it will always present a

flashing symbol on the display. The Buzzer symbol shows

whether the alarms will also use the buzzer.

If the Buzzer setting in the System Setup display is on

(indicating that the buzzer is enabled for all of the alarms),

this symbol will appear filled.

Operating Instructions

1 ... 35 36 37 ... 79

No comments

Raymarine FishFinder L265 User Manual Page 36