Raymarine GyroPlus Yaw Sensor Installation Manual download pdf (Page 14)

6 ST70 Pilot Controller Reference Guide

2.2 Dockside and open water procedures

WARNING: Dockside and open water procedures.

The ST70 Pilot must be prepared for use in accordance with the

Commissioning Procedures before it is used for operational purposes.

Failure to comply with this could result in death, personal injury, damage to

your boat and/or poor product performance.

The following procedures are described in the ST70 Autopilot Controller/SmartPilot X

Commissioning Instructions and should be performed in the prescribed order when

there is any change in vessel configuration:

• Vessel type

•Drive type

• Rudder check

• Motor check

• Compass calibration

• Auto learn.

2.3 General setup procedures

The setup procedures available depend on the vessel profile as set up during

commissioning (Fishing, Sail or Power), and whether the ST70 Pilot is in Standby or

Auto mode.

Procedure Sail Fishing Power

Pilot view (see Pilot view on page 22)xxx

Display settings (see Display settings on page 7)xxx

Autopilot calibration (refer to the ST70 Autopilot Controller/

SmartPilot X Commissioning Instructions)

xx x

Diagnostics (see Diagnostics on page 12)xxx

Response level (see Response Levels on page 14)xxx

Sailboat settings (see Sailboat setup procedures on

page 15):

Auto Tack

Gybe Inhibit

Wind Trim

Patterns (see Power boat and fishing boat setup procedures

on page 17)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

Raymarine GyroPlus Yaw Sensor Installation Manual Page 14