Raymarine 150/400 Installation Manual download pdf (Page 53)

Chapter 3: Adjusting SmartPilot Settings 45

3.3 User Calibration

The User Calibration group includes settings that you may need to adjust on

a regular basis due to changing conditions. The User Calibration options

(AUTO TACK, GYBE STOP, WIND TYPE, WIND TRIM and RESPONSE) are also

available via Dealer Calibration (see page 45). The SmartPilot Operating

Guide contains specific User Calibration instructions.

3.4 Seatrial Calibration

The Seatrial Calibration group has been designed specifically for use during

the initial seatrial when commissioning your SmartPilot. Refer to Chapter 2:

SmartPilot Commissioning for full details.

CAUTION:

You should not need to access Seatrial Calibration to adjust settings

during normal operation.

3.5 Dealer Calibration

The Dealer Calibration group includes items that have a significant impact

on SmartPilot operation and can affect your boat’s safety. Once you have

commissioned the SmartPilot, you should not normally need to alter the

Dealer Calibration values.

Accessing Dealer Calibration

To prevent accidental access, we have made entry to Dealer Calibration more

difficult than the other calibration groups:

To access Dealer Calibration:

ST6001 Controllers ST7001 and ST8001 Controllers

• press and hold the standby key for two

seconds to enter the Calibration mode

• when the screen shows DISPLAY CAL,

press the disp key until you see the

DEALER CAL screen

•press the auto key: the display will

change to CAL ?

•press -1 and +1 together to enter Dealer

Calibration mode

• press and hold the standby key for two

seconds to enter the Calibration mode

• when the screen shows DISPLAY CAL,

press the disp, up or down arrow

key until you see the DEALER CAL screen

• press the auto key: the display will

change to CAL ?

•press up and down arrow keys

together to enter Dealer Calibration mode

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 79 80

No comments

Raymarine 150/400 Installation Manual Page 53