Raymarine 150/400 Installation Manual download pdf (Page 42)

Chapter 3: Advanced Operation 29

3 Advanced Operation

3.4 Displaying data pages

Use the disp key to show ‘data pages’ of SeaTalk or NMEA data:

1. Press

disp to access the first data page, and press it again to cycle

through each data page in turn:

• to return to a previous data page, press

disp for 1 second

within 2 seconds of displaying a page

• when you cycle past the last data page, the display returns to

the current autopilot mode screen (for example, Auto)

• 4 data pages are set in the factory as a default (see diagram):

within User setup you can select up to 7 pages and control the

information they display (see page 81)

2. Select the data page you want to use as the main display:

• the current autopilot mode is shown at the left of the display

and the autopilot bar graph remains in use

• if you then select a new mode or make a course change, the

autopilot mode screen appears as a ‘pop-up’ for 5 seconds

Notes: 1. If the autopilot system cannot obtain the required

information, the data page will show dashes instead of a value.

2. The direction-to-steer arrows relate to the data page information.

3. Most data pages show repeated data so you cannot adjust them: the

exceptions are the

RESPONSE and RUDDER GAIN data pages, which

you can adjust using the

-1 and +1 keys

D5455-1

Autopilot mode

Data page 1

Data page 3

Data page 4

Data page 2

Default data pages

Press for 1 sec to

return to previous

data page

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 136 137

No comments

Raymarine 150/400 Installation Manual Page 42