Raymarine SeaTalk2 Setup Guide download pdf (Page 31)

Chapter 2: Installing the system 23

2.7 Pilot Controller

Fitting

The ST6002 Pilot Controller is supplied with an 4 m cable for connection to the

SeaTalk bus. Ensure that your mounting location is within 4 m of a suitable connection

point. You may purchase a longer cable if required.

Fit the controller in accordance with the separate instruction leaflet.

Connect controller and SeaTalk bus

The Pilot Controller connects to SeaTalk at the Course Computer, as shown in

following diagram.

Note:

You will need an additional cable to connect your controller to an existing SeaTalk instru-

ment.

SeaTalk power connections

The exact manner in which connections are made depends on how power is supplied

to SeaTalk:

• If power is supplied by the Course Computer, connect the red and yellow wires

and the screen to the Course Computer.

• If power is supplied from an external source, connect only the yellow wire and the

screen to the Course Computer. Do NOT connect the red wire.

D10619-1

Pilot Controller

SeaTalk

Screen

Red

Yellow

Connect Red wire only if SeaTalk

is to be powered from Course

Computer. See SeaTalk power

connections below, for details.

87076_1.book Page 23 Monday, March 10, 2008 2:57 PM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 73 74

No comments

Raymarine SeaTalk2 Setup Guide Page 31