Raymarine SeaTalk2 Setup Guide download pdf (Page 42)

34 SmartPilot X-5 Sport installation & Setup Guide

4. Check that the rudder moves to starboard a few degrees and then stops.

if the rudder drives hard over, immediately press standby to prevent further rud-

der movement.

5. If the rudder moves to port or the rudder drives hard over:

i. Press standby.

ii. Turn off the power.

iii. Reverse the motor wires connected to the SPX-5 Sport system computer.

iv. Switch on the power and re-check.

Note:

If the rudder overshoots and has to drive back or starts to hunt back and forth, you will

need to increase the rudder damping level manually (See page 55).

Step 4 - Dealer calibration settings

Introduction

To proceed with the dockside preparation, you need to carry out certain Dealer

calibration setup functions. The exact requirement and consequently the calibration

screens displayed, depend on whether a rudder reference transducer is fitted, as

summarized in the following diagram.

WARNING: Use Dealer calibration correctly

Improper use of Dealer calibration can seriously impair the

SPX-5 Sport system performance and therefore adversely

affect the steering capability. Do not change Dealer calibration

settings other than as described in the product documentation.

D10646-1

87076_1.book Page 34 Monday, March 10, 2008 2:57 PM

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 73 74

No comments

Raymarine SeaTalk2 Setup Guide Page 42