Raymarine ST60 Installation Manual download pdf (Page 17)

Chapter 1: Operation

Setting alarm conditions

The alarm threshold screens are accessed with the disp key (see the

Using the

disp

key flow chart), and enable you to switch alarms on or

off and set the alarm thresholds. The alarm threshold screens are:

• Maximum true wind speed alarm.

• Low true wind speed alarm.

• High apparent wind angle alarm.

• Low apparent wind angle alarm.

To set up an alarm, carry out the Switching alarms on and off, and

Setting alarm threshold procedures, as necessary.

Switching alarms on and off

Use the disp key to display the required threshold screen, then press

the tack key for approximately one-second, to toggle the alarm either

on (i.e. so the alarm threshold value is displayed) or OFF, as required.

Setting alarm thresholds

To set the required alarm threshold:

1. Use the disp key to display the required threshold screen, then

momentarily press the vmg and tack keys to enter the threshold

adjust mode (indicated by the displayed value flashing).

2. Use the vmg (decrement) or tack (increment) key to set the

required threshold value. You can set:

• The maximum (MAX) and minimum (LO) true wind speed, to

any value between 0 and 99 kts. Conflicting threshold values

cannot be set, i.e. you cannot set the MAX threshold to a lower

value than the LO.

• High (HI) and low (LO) apparent wind angle, to any value from

0 to 180

3. Momentarily press the vmg and tack keys to leave the threshold

adjust mode.

Note: The alarm threshold screens are not available on repeater

instruments so alarm thresholds can be set up only on master

instruments.

105_3c01.p65 06/04/01, 10:475

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

No comments

Raymarine ST60 Installation Manual Page 17