Raymarine ST60 Installation Manual download pdf (Page 29)

Chapter 3: Installation

Note: An ST60 Close Hauled Wind instrument can only be used as a

repeater instrument so a directly-connected transducer is not required.

Typical windvane installation

A windvane is typically mounted on a mast top, as follows:

1. With the threaded end of the windvane mounting block facing

forwards, mark the position of the two self-tapping screws.

2. Drill two holes using the 4 mm (5/32 in) drill bit (supplied).

3. Apply sealing compound to the bottom of the mounting block.

Typical transducer mounting

D4344-1

Rotavecta

Windvane

Packing piece

4. Secure the mounting block to the mast top using the two fixing

screws.

5. Insert the windvane into the mounting block connector and

tighten the locking ring securely by hand.

Fixing screws

Mounting block

Locking ring

Fitting wind vane

D4312-1

105_3c03.p65 06/04/01, 10:4717

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 49 50

No comments

Raymarine ST60 Installation Manual Page 29