Raymarine ST60 Installation Manual download pdf (Page 30)

ST60 Wind and Close Hauled Wind Instruments Owner’s Handbook

Rotavecta

The Rotavecta can be clamped to a 23 mm or a 25 mm rail by means of

an integral clamp. To fit a Rotavecta:

1. Dismantle the integral clamp, and ensure the pointed end of the

grub screw does not protrude through the top of the lower clamp

section.

2. If the rail is 25 mm diameter, set aside the two spacers. If the rail is

between 23 mm and 25 mm diameter, place the spacers in the

lower part of the clamp.

3. Offer up the lower part of the clamp (and spacers if used)

underneath the rail.

4. Place the rail mount disc on the upper side of the rail and place the

upper part of the Rotavecta on top of this, so that all the screw

holes are in alignment.

5. Secure all sections together using the two fixing screws, but do not

fully tighten at this stage.

6. Ensure the main shaft of the Rotavecta is vertical, then tighten the

two fixing screws.

7. Screw in the grub screw, to pinch the rail.

Clamp screws

Gasket

Adaptor

pieces

Grub screw

Rotavecta rail clamp

D4308-1

Running transducer cable

General

Each transducer type is supplied with sufficient cable already

connected, to run from the mounted position to the ST60 Wind

instrument. The manner in which you run the cable will depend on the

locations of the transducer and instrument. The following guidelines

are provided:

105_3c03.p65 06/04/01, 10:4718

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 49 50

No comments

Raymarine ST60 Installation Manual Page 30