Raymarine ST60 Installation Manual download pdf (Page 26)

ST60 Wind and Close Hauled Wind Instruments Owner’s Handbook

Flush mounting

The Flush Mounting Kit uses a low-profile bezel to reduce the fitted

profile of the instrument, to approximately 6 mm above the panel

fascia.

Fitting the low-profile bezel

In order to flush-mount your ST60 instrument, you must first replace

the standard bezel with the low-profile bezel as follows:

1. Hold the instrument in both hands with the display towards you.

D4537-2

2. Using both thumbs, gently press an upper corner of the instrument

from the bezel, then remove the bezel from the instrument. Retain

the rubber keypad which is released when the bezel is removed.

3. Place the instrument face upwards on a flat surface and place the

rubber keypad (7) in position around the display window (i.e. so

that each key outline is located over its associated key on the

instrument).

4. Snap the low-profile bezel (8) in position over the instrument, so

that the rubber keys are correctly located in the holes on the bezel.

CAUTION:

It is essential that only screws of the correct size are used to secure

the instrument to the bezel. Failure to observe this caution could

result in damage to both the instrument and the bezel.

5. Using the four, self-tapping screws (9) provided, secure the

instrument and bezel together. Fit the screws from the rear of the

instrument and tighten them sufficiently to secure the instrument

and bezel together. DO NOT OVERTIGHTEN.

105_3c03.p65 06/04/01, 10:4714

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 49 50

No comments

Raymarine ST60 Installation Manual Page 26