Raymarine ST60 Installation Manual download pdf (Page 33)

Chapter 3: Installation

A range of Raymarine SeaTalk extension cables is available to connect

separated instruments. These cables are supplied with a SeaTalk

connector fitted to each end. A junction box can be used to join cables.

Signal connections

Make the necessary connections to your ST60 instrument (see the

Connection to ST60 Wind instrument illustration). Although all

possible connections are shown:

• You can connect only one transducer type (either Rotavecta or

Wind Vane), to an ST60 Wind instrument. Do NOT attempt to

connect both types, even if both are fitted.

Note: If at any time, the transducer type is changed (e.g. a Wind Vane

is connected in place of a Rotavecta), use the procedures in Chapter 4,

Calibration to apply the factory default settings, then carry out the

linearisation and alignment procedures.

• The ST60 Close Hauled Wind instrument can only be connected to

SeaTalk; it does not have transducer connectors.

D4345-1

Blue

Red

Green

Yellow

Screen

Cable from Rotavecta

Cable from Wind Vane

SeaTalk cable SeaTalk cable

Connections to ST60 Wind instrument

Blue

Red

105_3c03.p65 06/04/01, 10:4721

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 49 50

No comments

Raymarine ST60 Installation Manual Page 33